A LCD PSP replacement is actually easy to do. In fact,
you need not be an expert to do it yourself. Knowing that the screen of this game is extremely susceptible to cracks and other damage, you should treat it with care. it is also important to know how to fix PSP screen appropriately.
If not properly protected, even a short fall can actually cause a broken PSP screen. If this happens, you can replace it, so you can continue to enjoy it.
The PSP screen is one of the weaknesses of this device. There could be an occasion where you will have to learn how to do a screen replacement. The best thing to do, when the screen becomes defective is to replace it right away.
You should not worry about the amount of money you will need for this replacement. You can easily find cheap PSP screen to replace it. Charges to fix PSP screen is also very affordable.
But before you actually buy a cheap screen, you need to know how to fix a broken PSP screen. In this tutorial, you will learn the proper way of removing the faceplate, screen assembly, and the LCD panel.
Remove five screws on the front cover using a Philips screw driver. The first two screws can be dislodged after removing the battery cover and of course the battery. The second screw is covered with the warranty sticker that you can just peel a little.
The third screw is on the PSP side. The last two screws are located on the memory stick. Hence, you need to be extra careful in removing these screws without removing the memory stick.
After you have removed all the five screws, it will be easy to detach the front cover or faceplate.
Using a flathead screwdriver, remove the control buttons at the bottom of the LCD. It is connected to the motherboard on the right side of the PSP by a little cable, which can be pulled out by lifting its clasp.
Pull out the screen from the LCD assembly. This is done by inserting a flathead screwdriver between the screen and the metal screen support. You can get the screen by releasing the clips on left side.
Remove the backlight and the LCD.
To completely remove the LCD, gently prey on the clips so the LCD ribbon slides out. Because this is very fragile, you need to be careful not to damage it otherwise your PSP will be useless.
Put in the new LCD PSP screen. Place it on the backlight and put back the front cover. Close the clasps after plugging the cables into the connectors.
Make sure all the clips are in place after you have placed the screen assembly back into the PSP.
Make sure the screen is working properly. Connect to the motherboard after you put the button bar back on top of the screen. Screw everything back together after you put the faceplate back on the PSP. You’re done with the easy and right way of doing LCD PSP replacement. 3/4 to mm